SBC8118 Texas Instruments AM1808 ARM926EJ-S 456 MHz SATA development kit

Based on the Texas Instruments AM1808 ARM926EJ-S 456 MHz

Mini8118 processor board

Processor
- Texas Instruments AM1808 microprocessor
- 375-MHz ARM926EJ-S RISC MPU, can operate at 456MHz
- ARM9 memory architecture
- Enhanced Direct-Memory-Access 3 (EDMA3) controller
- 128K-Byte On-chip Memory
Memory
- 128MByte Mobile DDR2
- 128MByte NAND Flash (on the bottom side of the board)
- 8Mb SPI Flash
The board-to-board connector supports
- Two 2.0mm 3*27-pindip
- TFT LCD signals (supports 16-bpp parallel RGB interface)
- Two-channel 8bit cameras
- One JTAG Debugger
- Two USB channels (one USB2.0 and one USB1.1)
- Five UART
- One SATA, supporting SATA I (1.5Gbps) and SATA II (3.0Gbps)
- One 10/100Mb/s Ethernet MAC(EMAC), including Management Data Input/Output（MDIO）.
- One 1/2/4/8 bit McASP DMA bus channel (some of the signals are multiplexed with network signals)
- One McBSP bus channel (with FIFO buffers, multiplexed with network signals)
- Four 64-bit universal timers (one configurable as a watchdog timer)
- Two SPI channels (SPI0 is multiplexed with MII)
- Two I2C channels (I2C1 is multiplexed with UART2)
- Two channels of 4-wire SDMMC
- 120 GPIO (most multi-functional input/output ports)
Mechanical parameters
- Dimensions: 58.0 mm*45.0 mm (6-layer tile)
- Operating temperature: -45°C ~ 85°C
- Humidity range: 20% ~ 90%
- Power supply: 3.3V

SBC8118 motherboard

LCD and touch screen
- Single interface TFT LCD connector (50pin FPC connector, RGB565)
- Four-wire resistive touchscreen interface
Communication interfaces
- Serial ports
- One 5-wire, RS232 (Debugger, DB9 connector)
- Two 3-wire, RS232, PRU SUART (DB9 connector)
- One 3-wire, TTL, PRU SUART (2.0mm 5pin connector)
- USB2.0 Host
- 2×USB2.0, USB-A
- 2× USB2.0, 2.0mm 5pin
- One SD card slot
- One RS485 interface
- One SATA interface, supporting SATA I (1.5 Gbps) and SATA II (3.0 Gbps)
- One 10/100Mbps Ethernet interface (RJ45 jack)
- One 14PIN JTAG connector
Input/output connectors and others
- Camera connector (30 PIN FPC, supports CCD or CMOS)
- One 4-pin SATA power connector, supports 2.5" HDDs
- One 4-bit DIP switch, supports boot mode selection
- One buzzer
- Two buttons (one user, one reset)
- Two LEDs (one power, one user)
Mechanical dimensions
- Dimensions: 160 mm * 100 mm
- Operating temperature: -45°C ~ 85°C
- Humidity: 20% ~ 90%
- Supply voltage: 12V @ 1.25A