BeMicro CV FPGA development kit

BeMicro CV FPGA development kit

The BeMicro CV Cyclone V E FPGA development board features Altera's 28-nm Cyclone V FPGA chip in the familiar BeMicro form factor. The Altera 5CEFA2F23C8N Cyclone V FPGA chip residing in the Be Micro CV is equipped with an enhanced memory controller (HMC) that supports DDR2, DDR3 and LPDDR3. On the BeMicro CV, the HMC is connected to a single 16-bit wide, 1Gb DDR3 SDRAM device.

Datasheet

https://www.intel.com/content/dam/support/us/en/programmable/support-resources/fpga-wiki/asset02/hardware-reference-guide-for-bemicro-cv-1.1.pdf

The BeMicro CV board features the following major component blocks:
- One Cyclone V E FPGA (5CEFA2F23C8N) in a 484-pin FineLine BGA (FPGA)25,000 LEs
9,434 adaptive logic modules (ALMs)
1,760 Kbit (Kb) M10K and 196 Kb MLAB memory
4 fractional phase locked loops (PLLs)
50 18×18-bit multipliers
1 Hard Memory Controller
224 general purpose input/output (GPIO)
1.1-V core voltage
- FPGA configuration circuitry
Active Serial (AS) x1 configuration (EPCS16I8N)
Embedded USB-BlasterTM II for use with the Quartus® II Programmer
Separate JTAG configuration header
- Clocking circuitry
50 MHz 1.8V oscillator
24 MHz 2.5V oscillator
- Memory
1Gbit DDR3 SDRAM (x16)
1K (128 x 8) Two-wire Serial EEPROM
Micro SD card slot
- General user input / output
8 user LEDs
2 User Pushbuttons
3 User DIP switches
- Prototyping
2 Terasic 40 pin prototyping headers
BeMicro SDK 80-pin card edge connector
Micro SD card slot
- Power via USB or via user-provided 5V supply